System information

13
The table below shows which sensors are used in which operating mode.
Heating modes
Depending on the sensors used, the following heating modes
are available:
Heating – fixed supply
Heating – outdoor controlled supply
Heating – outdoor controlled supply with indoor
compensation
Heating – indoor contolled
Heating – outdoor controlled average
Cooling modes
Depending on the sensors, the following cooling modes are
available:
Cooling – fixed supply
Cooling – indoor controlled
Cooling – indoor compensated supply with dew point
control
Up to six humidity sensors help to avoid condensation reliably.
The wireless connection allows free placement of the sensors.
G r e a t t o r e s p o n d c h a n g e s i n u s a g e o r a r c h i t e c t u r e a t a n y t i m e !
Clever combination of heating and cooling modes
The following switchover modes are available:
H/C Switchover – indoor-outdoor temperature controlled
(temperature readings from the indoor and outdoor sensors)
H/C Switchover – supply temperature controlled
(depending on the primary supply water temperature)
H/C Switchover – manual mode
(when the user manually sets it in either mode)
H/C Switchover – slave mode
(controlled from an external source)
Snow and ice melting modes
The figure shows how the Climate Controller C-46 can be set
up in a snow and ice melting system. The figure also shows
several system components that can be connected to the
Climate Controller C-46. Note! Only Uponor sensors and
equipment should be used in combination with the Climate
Controller C-46.
The following operation modes are available:
Snow and ice melting – idle setpoint
Snow and ice melting – melting supply setpoint temperature
Three basic modes of operation,various diversifications
Operation modes
Operating mode Supply
sensor
Outdoor
sensor
Indoor
sensor
Return
sensor
Relative
humidity
sensor
Floor
sensor
Heating – fixed supply X
Heating – outdoor controlled supply X X O
Heating – outdoor controlled supply with indoor compensation X X X
Heating – outdoor controlled average X X X
Heating – indoor controlled X X
Cooling – fixed supply X O
Cooling – indoor controlled X X O
Cooling – indoor compensated supply with dew point control X X X X O
Snow and ice melting X X
X = the sensor must be used in this operating mode
O = the sensor is optional