Installation manual

Uponor Control System - Installation Manual 9
3.3.3.1 Connection without Timer option
Connect thermostat and terminal:
"Com" and "No timer": The installation will work in a
standard way with the thermostats regulating each room
according to their set temperatures. Reduced mode is not
available.
Example of an installation wired without Timer:
Thermostat #01 controls the actuator on channels 01a
and 01b and channels 02a and 02b.
Thermostat #03 controls the actuator on channel 03 and
controls channel 04.
Thermostat #05 controls the actuator on channel 05 to
channel 11.
Thermostat #12 controls channel 12.
3.3.3.2 Connection with Timer option in Heating only mode
(Only 12-channel controller)
Connect thermostat and terminal:
• "Com" and "No timer": The installation will work in a
standard way with the thermostats regulating each room
according to their set temperatures.
• "Com" and "Zone 1" (allocate the thermostat to Zone 1):
The corresponding channel will run in Comfort mode
according to the time slots in Zone 1 of the timer.
Example: Zone 1 (for settings see timer manual)
• "Com" and "Zone 2" (allocate the thermostat to Zone 2):
The corresponding channel will run in Comfort mode
according to the time slots in Zone 2 of the timer.
Example: Zone 2 (for settings see timer manual)
To connect the timer, see the wiring diagram in the
fold-out.
One of the thermostat's two wires will always be
connected to the “Com” quick connector and the
second to one of the remaining three quick
connectors, depending on the mode selected
(non-polarized).
night morning
evening
night
COMF
ECO
E
CO
night
evening
night
morning
COMF
INSTALLATION_MANUAL_R3-04A.mif Page 9 Mercredi, 14. mars 2007 11:34 11