Installation manual

Uponor Control System - Installation Manual 13
3.4 Thermostats
The Uponor Control System may be controlled with three
types of thermostats.
• Thermostat T-35 wired:
Adjust the temperature with the dial. The dial must be
removed to set min/max on the thermostat.
• Thermostat Public T-33 wired:
The thermostat is designed for public location.
The potentiometers used for the settings are protected
with a cover. This thermostat also can be used to connect
a floor sensor option.
• Thermostat T-37 wired for floor sensor:
Adjust the temperature with the dial. The potentiometers
used for the settings are protected with a cover. The dial
and the cover must be removed to set up min/max on
the thermostat. This thermostat also can be used to
connect a floor sensor option.
3.4.1 Opening the thermostats
3.4.2 Mounting and wiring the thermostats
3.4.2.1 Location of a thermostat
(For all thermostats)
•On an indoor wall.
• 1.5 m to 1.8 m from the floor.
• Away from any source of humidity. (IP20)
• Away from any source of heat (television, electronic
equipment, fireplace...).
• Away from direct solar radiation.
• Away from direct water splashes.
3.4.2.2 Thermostat fixation
Fixing on the wall:
Drill the wall (Ø6 mm). Fix anchors in the wall.
Let the screw protrude from the box (3 mm).
Screw the thermostats on the wall or/and on the box.
INSTALLATION_MANUAL_R3-04A.mif Page 13 Mercredi, 14. mars 2007 11:34 11