Technical data

9.12 Set minimum/maximum temperatures
Example: If the temperature set point of the thermostat is set
to 5 °C, the temperature will not fall below 12 °C because the
minimum and maximum limitations for this room are set to 12
and 26 °C respectively.
To set minimum and maximum temperatures:
1 On the Uponor screen, select Main Menu > Settings >
Rooms > Min/Max Temperatures.
2 Select the desired controller or All for
all rooms on all controllers and press
OK.
Selecting All sets the same minimum
and maximum temperatures for all
rooms.
3 Select a thermostat or room and press
OK.
4 Set the temperatures. Use
and
to increase and decrease the value.
Use
and to toggle between
minimum and maximum.
Press OK.
9.13 Disable cooling
Use this setting to exclude specifi c rooms from cooling mode,
for example, a bathroom or garage. This menu is displayed only
when cooling is activated during installation.
To disable cooling:
1 On the Uponor screen, select Main Menu > Settings >
Rooms > Disable Cooling.
2 Select the controller (applies only
when more than one is installed)
and press OK.
3 Select a thermostat or room and
press OK.
4 Select Yes to disable cooling for the
room (or all rooms) and press OK.
9.14 Set temperature unit
To set the temperature unit:
1 On the Uponor screen, select Main Menu > Settings >
System Parameters > Temperature Unit.
2 Select °C or °F and press OK.
9.15 Set time and date
To set the time and date:
1 On the Uponor screen, select Main Menu > Settings >
System Parameters > Clock Settings > Set Date/Time.
Toggle between the fi elds using the
and keys.
Change the values using the
and keys.
2 Change the time and date and press
OK.
Set time format
To set time format:
1 On the Uponor screen, select Main Menu > Settings >
System Parameters > Clock Settings > Time Format.
2 Select 24 hour or AM/PM and press
OK.
Set date format
To set date format:
1 On the Uponor screen, select Main Menu > Settings >
System Parameters > Clock Settings > Date Format.
2 Select the format and press OK.
39
UPONOR CONTROL SYSTEM – INSTALLATION AND OPERATION MANUAL
UK English