Technical data

9.4 Access and navigate menu
To access room information from the menu:
1 Press the OK navigation key to display the Main Menu.
2 Select Information and press OK.
The information menu is displayed.
3 Select Rooms and press OK. The list
of rooms is displayed.
4 Select the desired room and press
OK. Information for the selected
room is displayed.
5 Display the desired information
using the navigation keys.
Use
and to display the
previous/next screen.
Use
and to display the
previous/next thermostat.
Press OK to return to the room list.
9.5 Select access level
Two access levels are available for operation:
• Basic allows the users to view basic information but not to
modify settings. Basic mode can be used in a public location
or rented accommodation, for example.
• Advanced allows users both to view and modify settings.
To select the access level:
1 On the Uponor screen, select Main Menu > Settings >
System Parameters > Access Level.
2 Select Basic or Advanced and
press OK.
To switch from Basic to Advanced level, on the Uponor screen,
simultaneously press
and until the Advanced screen
appears.
Select Advanced and press OK to put the system in advanced
level.
9.6 Display room information
The digits at the beginning of the room name on the display
mean:
• 1
st
digit – controller number (1, 2, 3).
• 2
nd
and 3
rd
digits – number of the fi rst channel controlled by
this thermostat (01, 02, 03, and so on). If several channels
are controlled by the thermostat, only the lowest channel
number is displayed.
To display room information:
1 On the Uponor screen, select Main Menu > Information >
Rooms.
2 Select the desired room and press OK.
Meanings of the temperature icons as shown in the example
screens below.
Icon Description of use Screen example
If temperature set on thermostat
is outside allowed temperature
range for room, limitation
temperature is displayed as set
point.
Measured temperature is 21.2 °C.
Temperature setting for room
when in ECO mode. (Current
setting 19 °C).
Options for current status:
COMF: Comfort mode.
ECO: Economy mode.
This screen is displayed if there is
a fl oor sensor in the room. Floor
temperature is 23 °C.
Max and Min - Minimum and
maximum fl oor temperature set
point is displayed.
9.7 Display battery and communication status
To display battery and communication status:
Icon Description Screen example
Battery: batteries are suffi ciently
charged.
Signal: radio signal from the
thermostat and antenna is good.
Battery: batteries are
discharged.
Signal: radio signal from antenna
or thermostat is poor or faulty.
37
UPONOR CONTROL SYSTEM – INSTALLATION AND OPERATION MANUAL
UK English