Installation and Operation Manual
Communication module R-208
Pollution degree 2
Software class A
Operating temperature 0 °C to +45 °C
Storage temperature -20 °C to +70 °C
Wi-Fi connectivity 802.11 b/g/n @2.4Ghz
Wi-Fi security WPA & WPA2
Radio frequency 912 MHz
Transmitter duty cycle <1%
Receiver class 2
Connection terminals RJ45 Ethernet connection (10/100BaseT)
Room controller X-265
IP IP20, class II (IP: degree of inaccessibility to active parts of the product
and degree of water)
Max. ambient RH (relative humidity) 85% at 20 °C
CE marking
ERP (with communication module and the Uponor Smatrix PULSE app) VIII
ERP (without communication module and the Uponor Smatrix PULSE
app)
IV
Low voltage tests EN 60730-1* and EN 60730-2-9***
EMC (electromagnetic compatibility requirements) tests EN 60730-1 and EN 301-489-3
ERM (electromagnetic compatibility and radio spectrum matters) tests EN 300 220-3
Power supply
115 V AC +10/-15%, 50 Hz or 60 Hz
Internal fuse T5 F3.15AL 250 V, 5x20 3.15A quick acting
Rated impulse voltage 2.5 kV, OVC II
Pollution degree 2
Software class A
Operating temperature 0 °C to +45 °C
Storage temperature -20 °C to +70 °C
Maximum consumption 45 W
Pump and boiler relay outputs
24 V AC +10/-15%, 24 V AC 8 A maximum
Micro gap, normally open
General purpose input (GPI) Only dry contact
Valve outputs 24 V AC, 0.2 A average, 0.4 A peak
Power connection 1 m flexible cord, with europlug (except UK), which is connected to the
controller
Connection terminals for power, pump, GPI and boiler Up to 4.0 mm² solid, or 2.5 mm² flexible with ferrules
Connection terminals for valve outputs 0.2 mm² to 1.5 mm²
*) EN 60730-1 Automatic electrical controls for household and similar
use -- Part 1: General requirements
**) EN 60730-2-1 Automatic electrical controls for household and
similar use -- Part 2-1: Particular requirements for electrical controls
for electrical household appliances
***) EN 60730-2-9 Automatic electrical controls for household and
similar use -- Part 2-9: Particular requirements for temperature
sensing controls
15.2 Cable specifications
Cables Standard cable length Maximum cable length Wire gauge
Cable from room controller to
antenna
3 m 5 m CAT.5e or CAT.6, RJ 45 connector
Cable from room controller to
communication module
2 m 5 m CAT.5e or CAT.6, RJ 45 connector
Cable from room controller to
actuator
0.75 m 20 m Room controller: 0.2 mm² to 1.5
mm²
External sensor cable to thermostat 5 m 5 m 0.6 mm²
Uponor Smatrix Wave PULSE
|
Installation and operation manual
|
77