Installation and Operation Manual
1 Copyright and disclaimer
Uponor has prepared this installation and operation manual and all
the content included solely for information purposes. The contents of
the manual (including graphics, logos, icons, text, and images) are
copyrighted and protected by worldwide copyright laws and treaty
provisions. You agree to comply with all copyright laws worldwide in
your use of the manual. Modification or use of any of the contents of
the manual for any other purpose is a violation of Uponor’s copyright,
trademark and other proprietary rights.
The presumption for the manual is that the safety measures have
been fully complied with and, further, that Uponor Smatrix control
system, including any components that are part of such system,
covered by the manual:
• is selected, planned and installed and put into operation by a
licensed and competent installer in compliance with current (at
the time of installation) installation instructions provided by
Uponor as well as in compliance with all applicable building and
plumbing codes and other requirements and guidelines;
• has not been (temporarily or continuously) exposed to
temperatures, pressure and/or voltages that exceed the limits
printed on the products or stated in any instructions supplied by
Uponor;
• remain in its originally installed location and is not repaired,
replaced or interfered with, without prior written consent of
Uponor;
• is connected to potable water supplies or compatible plumbing,
heating and/or cooling products approved or specified by
Uponor;
• is not connected to or used with non-Uponor products, parts or
components except for those approved or specified by Uponor;
and
• does not show evidence of tampering, mishandling, insufficient
maintenance, improper storage, neglect or accidental damage
before installation and being put into operation.
While Uponor has made efforts to ensure that the manual is accurate,
Uponor does not guarantee or warrant the accuracy of the
information contained herein. Uponor reserves the right to modify the
specifications and features described herein, or discontinue
manufacture of the Uponor Smatrix products described at any time
without prior notice or obligation. The manual is provided “as is”
without warranties of any kind, either expressed or implied. The
information should be independently verified before using it in any
manner.
To the fullest extent permissible, Uponor disclaims all
warranties, expressed or implied, including, but not limited to,
the implied warranties of merchantability, fitness for particular
purpose and non-infringement.
This disclaimer applies to, but is not limited to, the accuracy, reliability
or correctness of the manual.
Under no circumstances shall Uponor be liable for any indirect,
special, incidental or consequential damages or loss that result
from the use of or the inability to use the materials or
information in the manual, or any claim attributable to errors,
omission or other inaccuracies in the manual, even if Uponor
has been advised of the possibility of such damages.
This disclaimer and any provisions in the manual do not limit
any statutory rights of consumers.
4
|
Uponor Smatrix Wave PULSE
|
Installation and operation manual
Compliance
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) 1) This device may not
cause harmful interference,
and
(2) 2) This device must accept any interference
received, including interference that may cause
undesired operation.
Note: The grantee is not responsible for any
changes or modifications not expressly approved by
the p
arty responsible for compliance. Such
modifications could void the user’s authority to
operate the equip
ment.:
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the
following two conditions:
FCC ID: V9MSMATR1
IC: 7664A-SMATR1
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference,
including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu
dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
1) L’appareil ne doit pas produire de
brouillage;
2) L’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Compliance
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received,
including interference that may cause undesired operation.
Note: The grantee is not responsible for any changes or
modifications not expressly approved by the party responsible
for compliance. Such modifications could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and
receiver.
—Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician
for help.
This device contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
L’émetteur/récepteur exempt de licence contenu dans le
présent appareil est conforme aux CNR d’Innovation, Sciences
et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement.
FCC ID: V9MSM4NA0 and V9MSM4NA1
IC: 7664A-SM4NA0 and 7664A-SM4NA1