User Guide

10 l uponorengineering.com
FORCELOGIC
expansion head
installation
The Milwaukee FORCELOGIC
ProPEX Expansion Tool for 2",
2½" and 3" Uponor PEX pipe
features an auto-rotating
head with specially designed
alignment cogs. This requires
slightly different head
installation than the M12 and
M18 ProPEX expansion tools
for ⅜" to 1½" pipe sizes.
1. Remove the battery pack
and place the
FORCELOGIC tool in the
upright position (cone up).
2. Verify the expansion cone is
fully retracted.
3. Screw the head onto the
tool (clockwise). Hand-
tighten securely. Do not
over tighten. Ensure the
expansion head ts ush
against the tool.
4. Check the installation.
a. Ensure the head
segments do not “ower”
(see image 4a).
b. If the head owers,
correct the installation
by loosening the head
slightly and rotating the
segments until they
engage in the cogs. Re-
tighten the head.
c. Rotate the six expansion
segments in the clockwise
direction. They will rotate
freely. They should not
rotate counterclockwise.
d. The expansion head
collar will t ush against
the tool.
Making ProPEX
connections
with Milwaukee
M18 FORCELOGIC
ProPEX expansion tools
1
Correct expansion
head alignment
4b
Incorrect expansion
head “owering”
4a
Auto-rotate teeth