Installation guide

www.uponor-usa.com • www.uponor.ca
32
Exercise Actuators and Pumps
This exercise maintains the functionality of the
actuators and pumps. A ve-minute activation
is scheduled every week.
Cancel Exercise
1. Uponor screen
> Main Menu > Settings > System
Parameters
> Valve/Pump Exercise > Cancel Exercise
2.
> Press OK.
Exercise Valve and Pump
1. Uponor screen
> Main Menu > Settings > System
Parameters
> Valve/Pump Exercise > Exercise Valve
and Pump
2. Set the time and date for the
ve-minute activation.
> Press OK.
Exercise Actuator Only
1. Uponor screen
> Main Menu > Settings > System
Parameters
> Valve/Pump Exercise > Exercise
Valve Only
2. Set the time and date for the ve-
minute activation.
> Press OK.
Temperature Unit
1. Uponor screen > Main Menu >
Settings
> System Parameters >
Temperature Unit
2.
>°C or °F
> Press OK.
Backlight
1. Uponor screen > Main Menu >
Settings
> System Parameters >
Backlight
2. Select:
Always ON
Dimmed (when inactive): reduced screen brightness
OFF (when inactive): backlighting off
> Press OK.
Installer Level
The device has another mode: the Installer
level. Only the installer should set these
settings.
The Installer access level provides additional access to:
• The information menu
• All advanced level parameters
• Pump management settings
• Base unit identication
• Language
Vacation Mode
Vacation mode allows the user to easily set a temperature
reduction common to all rooms. The thermostat settings
are ignored during this period. The symbol
on the
Uponor screen indicates that the system is in
Vacation mode.
• The reduce vacation setpoint applies
throughout the installation for all installed
room thermostats. The setting range is
41°F to 95°F.
• The minimum and maximum limitations have
priority over the Vacation mode reduction.
For example if the minimum and maximum
temperature range of a room is set to 68°F
to 77°F, and the holiday temperature is set
to 59°F for all rooms, the temperature for
this room will not drop below 68°F.
Applying the Vacation Mode
1. Uponor screen > Main Menu > Vacation Mode >
Apply Vacation Mode
2. Enter time and date for the start
of the vacation period
> Press OK.
3. Enter time and date for the end
of the vacation period
> Press OK.
4. Enter the Vacation temperature
setpoint > Press OK.
Example: Vacation Mode can be cancelled before the
date is entered into the system.
Cancelling the Vacation Mode
1. Uponor screen > Main Menu > Vacation Mode >
Cancel Vacation Mode
2. Select Yes > Press OK.
Exercise Valve and Pump
Exercise Valve Only
Cancel Exercise
Exercise Setup
Monday
1 : 00
Exercise Time
Monday
1 : 00
Exercise Time
Please choose the
required temp unit.
˚C
˚F
Temperature Unit
Dimmed (when inactive)
OFF (when inactive)
Always ON
Backlight
14 Jan 2008
2 : 02
Set Date/Time
15 Jun 2008
2 : 02
End Date
59˚F
Vacation Te mperature
Cancel Vacation
Mode?
Yes
No
Cancel Vacation Mode