Installation guide

www.uponor-usa.com • www.uponor.ca
30
Settings Menu
The settings menu allows the user to set the base unit for
individual rooms.
The number at the beginning of the room
name on the display means:
First digit: base unit number (1, 2, 3); second
and third digits: number of the rst channel
controlled by this thermostat (01, 02, 03, ...).
(If several channels are controlled by the same
thermostat, only the lowest terminal number
is displayed.)
Assigning or Changing a Room Name
1. Uponor screen > Main Menu > Settings > Rooms
> Room Names
2. Select the desired controller (only
applies if more than one controller
is installed) > Press OK.
3. Select the desired room or
thermostat. > Press OK.
4. Select the room name from the
predened list. > Press OK.
Setting the Min and Max Temperatures
1. Uponor screen > Main Menu > Settings > Rooms >
Min / Max Temperatures
2. Select the desired base unit or All
for all rooms on all base units >
Press OK.
Selecting All sets the same min and max
temperatures for all rooms.
3. Select the desired thermostat or
room.
> Press OK.
4. Set the temperatures
Use
and to increase and
decrease the value.
Use
and to toggle between
min. and max.
> Press OK.
Example: If the temperature setpoint of the
thermostat is set to 41°F, the temperature will
not fall below 53.6°F because the minimum
and maximum limitations for this room are set
to 53.6°F and 78.8°F respectively.
Information Menu: System Information
Heating Mode
Uponor screen
> Main Menu > Information > System >
Operating Mode
Operating Mode
The system is always in heat mode.
Access Level
Uponor screen
> Main Menu > Information > System
> Access level
Displays the current access level.
Software Version
Uponor screen
> Main Menu > Information > System
> Software Version
Software Version
Hardware Version
ECO Mode
Reset proles to the default values by
re-editing. In heat mode, ECO mode reduces
room temperatures at the set times. There are
ve different time and temperature proles
available, and all can be modied.
Steps to Follow
1. Edit the ECO proles.
2. Apply the ECO proles.
ECO Prole
This system provides ve periods for
temperature reduction settings, which indicate
each setting, but are fully programmable.
Set the timers rst. Then dene which
thermostat each timer is to control.
Heating
ECO Off
ECO All
X.X.X
Interface : 1.0.16 (1.0.2)
#1 Base Unit : 1.0.17 (1.0.3)
#2 Base Unit : 1.0.17 (1.0.3)
Software Version
Mode
Heat.
Operating Mode
OK
Basic
Access Level
(X.X.X.)
�
Base Unit List
Controller 1
Controller 1
All
Base Unit List
1.07 Gym
1.02 Living
Room List
1.07 Gym
1.02 Living
Room List
Master BD
Dining
Living
Default Room Names
Max
500˚F
Min/Max temperatures
Min
248˚F