Install Instructions

5
4
www.uponorpro.com
Fast Trak™ Installation Guide
4
Refer to the following instructions to properly install Fast Trak 0.5.
1. Before installation, ensure the subsurface is dry, firm and clean.
Dirt, debris or dust on the subsurface will hinder adhesive
adherence. Ensure the panel has a proper grip to the subsurface
and the subsurface has a sufficient load-bearing capacity (use a
suitable leveling compound to achieve this, if necessary).
2. Install the Edge Strips, making sure the polyethylene (PE) foil is
laying down on the subsurface.
Note: Ensure the Edge Strips extend from the load-bearing subsurface to
the upper edge of the floor covering.
Figure 4: Install Edge Strips
Figure 5: Proper Edge Strip Location
DO NOT allow a gap
between the edge strips.
DO NOT allow seams in
inner or outer corners.
Ensure Edge Strips prevent
overpour from seeping under
panels to protect surrounding
structure from moisture damage.