Operating Instructions and Installation Instructions

2 “AA” size batteries (included)
Wire Stripper/Cutter
(If necessary, to strip the wires)
Level
(If necessary, to level the thermostat)
Masking Tape
(To wrap the exposed wires temporarily and labeling
the disconnected wires)
Power drill with a 3/16” bit
( If necessary, to drill holes on the wall )
( ) screwdriver
Installation
The following tools may be required for installation:
See below to select a suitable place for the new thermostat installation. And refer to the "Replacing
Old Thermostat" section on page 26 to replace an old thermostat.
24
-
“AA” SIZE
+
- +
“AA” SIZE