Operation Manual

6
PROGRAM THE RECEIVER
The receivers must be programmed to recognize signals
from the remote control. Each receiver must be assigned
a channel from 1 to 10. Receivers may be given their own
channel, enabling the remote to control each unit
individually, or they may be controlled as part of a group.
Any receivers assigned to the same channel group will be
issued the same commands at the same time.
(For example, one may choose to activate their lighting
and home stereo system with a single command.)
1) Place the receiver in the wall socket.
2) Press [FUNCTION] [6]
3) Select channel (1-10), for example, press [1]
4) Press down any of the buttons on the receiver
within 10 seconds. The red light on the receiver will
start to flash to indicate that the receiver has detected
the signal from the remote control. [OK] appears on
screen to inform you that the signal detection IKT201
has ended.
5) Press [FUNCTION] on the remote control. If you have
several receivers, repeat steps 1-5 choosing other
channels. (up to 10 channels.
OK