Operation Manual

20
DIMMER RECEIVER (IKR203)
DIMMER RECEIVER (figure 2 - DIAGRAM SECTION)
The dimmer receiver is only intended for dimming lighting units.
Do not connect CFL or fluorescent lights to this unit. The maximum
load for the IRK203 is 200W.
Installation:
1) Insert the dimmer receiver in the outlet socket.
The main green light will be on whenever the receiver
is connected to a power supply.
2) Connect the lamp(s) to the receiver.
Manual on/off:
1) Press [ON/OFF] to switch the lamp on or off. The red output light will
be on whenever the receiver is plugged in and connected to a lamp.
Manual brightness:
Press [UP] to increase the brightness.
Press [DOWN] to reduce the brightness.
The receiver will store in it’s memory the brightness setting.
For example, if you switch off the lamp at a set brightness level 5,
it will switch on the lamp at the brightness level 5 as well.