User manual
Table Of Contents
- About This Manual
- 1 VLAN Configuration
- VLAN Overview
- Configuring VLAN
- Creating VLAN
- Creating a VLAN in VLAN Database
- Setting VLAN Name
- Setting VLAN Link Type on Ethernet Interface
- Adding VLAN Member Port
- Adding Ports to a VLAN in Batches
- Setting the Native VLAN for a Trunk or Hybrid Port
- Setting VLAN Filtering on a Port
- Setting Frame Filtering Type of a Port
- Creating VLAN Layer 3 Interface
- VLAN Configuration Example
- Configuring PVLAN
- Configuring QinQ
- Configuring Subnet VLAN
- Configuring Protocol VLAN
- Configuring VLAN Translation
- Configuring SuperVLAN
- VLAN Maintenance and Diagnosis
- 2 SVLAN Configuration
- 3 SVLAN COS Configuration
- 4 ZESR and SVLAN Linkage Networking Configuration
- 5 MAC Address Table Configuration
- Introduction to MAC Address
- Configuring MAC Address Table
- Setting MAC Address Aging Time
- Burning MAC Addresses
- Configuring MAC Address Permanent
- Binding MAC Address to a Port
- Enabling MAC Address Learning
- Limiting MAC Address Count
- Setting MAC Address Learning Protection
- Setting Port Unkown Source MAC Address Filtering
- Setting MAC Address Filtering
- Viewing MAC Address Table
- MAC Address Table Configuration Example
- 6 STP Configuration
- 7 Link Aggregation Configuration
- 8 IGMP Snooping Configuration
- 9 Sflow Configuration
- 10 ZESS Configuration
- 11 Ethernet OAM Configuration
- 12 UDLD Configuration
- 13 LLDP
- 14 L2PT Configuration
- Figures
- Tables
- Glossary
Chapter1VLANConguration
CommandFunction
ZXR10(config-gei_1/x)#ingressfiltering{enable|disab
le}
ThissetsVLANlteringona
port.
Wheningresslteringisenabledonaport,theportdropsare-
ceivedframeiftheVLANtowhichtheframebelongsdoesnot
includetheingress.Bydefault,VLANingresslteringisenable.
SettingFrameFilteringTypeofaPort
Tosetframelteringtypeofaport,usethefollowingcommand.
CommandFunction
ZXR10(config-gei_1/x)#acceptableframetypes{all|tag}Thissetsframelteringtypeof
aport.
Thissetstheframetypeoftheportwhichcanreceivealltypes
offramesincludinguntaggedandtaggedframes.Bydefault,all
framesarereceived.
CreatingVLANLayer3Interface
CommandFunction
ZXR10(config)#interface{vlan<vlan-id>|<vlan-if>}
ThiscreatesVLANlayer3
interface.
ItisnecessarytocreatethisVLANbeforecreatingVLANlayer3
interface.
VLANConfigurationExample
Theportsgei_1/1andgei_1/2onSwitchA,andtheportsgei_1/1
andgei_1/2onswitchB,belongtoVLAN10;theportsgei_1/4
andgei_1/5onswitchA,andtheportsgei_1/4andgei_1/5on
switchB,belongtoVLAN20.Thefourportsareallaccessports,
asshowninFigure3.SwitchesAandBareconnectedthrough
portsgei_1/24(twotrunkports)overatrunklink.
CondentialandProprietaryInformationofZTECORPORATION9