Instructions / Assembly

ManualsBrandsUPHA ManualsFire Pit Patio Sets8 Pieces Outdoor Fire Pit Patio Set with 42 in. Iron Propane Fire Pit Table, Coffee Table and Navy Blue Cushions

OPERATION

FOR YOUR SAFETY, READ BEFORE LIGHTING

1. Turn the cylinder valve on the gas tank counter-clockwise to open the gas supply.

2. Close the storing door on the firebowl for the gas tank.

3. Press and hold the Electric Ignitor. Meanwhile, push and turn the Control Knob counter-clockwise to the "LOW" position. Keep pushing the Control

Knob to light the burner.

4. After ignition, release the Electric Ignitor. Continue to push and hold the Control Knob for 45 seconds.

5. If ignition does NOT immediately take place in seconds, push and turn the Control Knob clockwise to "OFF". Wait 5 minutes, then repeat the lighting

procedure as above.

6. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury.

Push the Control Knob and turn clockwise to the "OFF" position.

Turn the cylinder valve on the gas tank clockwise to close the gas

supply if not in use for a long time.(See figure below)

HOW TO EXTINGUISH ?

IGNITER-PUSH

ALLUMEUR-POUSSER

LIGHTING

1.Read the instructions before lighting. 2.Control knob must be in " OFF" position. 3.Connect propane cylinder(See Manual).

4.Push and turn control knob counter clockwise to Low. 5.Press the igniter button repeatedly to light burner.

6.Release control knob after 45 seconds. 7.If ignition does not occur in 4s seconds,push and turn burner control knob to "OFF",

wait 5 minutes,fan with newspaper or magazine,and repeat lighting procedure.

8.lf ignite does not light burner,use a long match or a long butane lighter.9.Adjust flame to desired flame with the control knob

CAUTION:The gas supply must be turned off at the LP-gas supply cylinder when this appliance is not in use.

TURNING OFF

1. Turn and push the control knob clockwise to the "OFF" position. 2.Turn the cylinder valve on the gas tank clockwise to close.

ALLUMAGE1. Lisez les directives avant l'allumage. 2.ll faut que le bouton de commande soit a la position "ARRET"

3.Raccorder la bouteille de propane (voir le guide) 4.Pousser et toumer le bouton de commande dans le sens anti-horaire à "BAS"

5.Appuyer sur le bouton d'allumage plusieurs fois pour allumer le brûleur6.Relâcher le bouton de commande après 45 secondes.

7.Si l'allumage ne s'est pas produit pendant les 45 secondes.pousser et tourner le bouton de commande jusqu'a la position

“ARRET", attendre 5 minutes éventer avec un joumal ou une revue repétér ensuite

le procédé d'allumage

8.Si l'allumeur n'allume pas le brüleur ,utiliser une allumette

longue ou un long allume-feu au butane

9. Régler la flamme à l'intensité voulue à l'aide du bouton de commande.

ATTENTION: II faut fermer le robinet gaz sur la bouteille de

GPL lorsque

I' appareil n'est pas utilisé

EXTINCTION:

1.Tourneret pousser le bouton de commande

dans le sens horaire jusqu 'à la position

"ARRET"

2. Tourner le robinet de la bouteille de gaz

dans les sens horaire pour le fermer.

LOW

(BAS)

OFF(ARRET)

HIGH(ELEVE)