Instructions / Assembly

2
PLEASE READ THE FOLLOWING SAFETY RULES PRIOR TO OPERATION OF THE HEATER
WARNING
The installation of this unit must adhere to local codes or either the National Fuel Gas Code, ANSI Z223. 1/NFPA54, OR CAN/CGA- B149.1, National
Gas and Propane Installation Code.
This unit is to be used with propane gas only! (sold separately), is not intended for natural gas.
Do not use any solid fuel or charcoal for this unit.
Do not use any more than 1/4in depth lava rocks/pumice stones/Lava Glas above the burner holes. Doing so will suffocate the flame.
Applying too much propane may result in gas pooling and will not burn. Allow fresh air into the unit so that the remaining gas may escape.
Use LP propane tanks with the following dimensions: diameter 12inch, height 18inch, capacity 20lbs.
You must use a propane tank that has a collar to protect the gas valve.
The LP gas tank must have a listed overfilling prevention device and a QCCI or Type I, (CGA810) LP gas tank connection.
The gas supply tank should be constructed and marked with the specifications for the LP gas tanks of the U.S. Department of Transportation or the
National Standard of Canada CAN/CSA-B339, LP gas tanks, spheres and tubes for Transportation of Dangerous Goods and Commission.
Discontinue use if any part of the propane tank is damaged. Rust and dents may be hazardous and should be inspected by a gas supplier.
DO NOT fill tank over 80 Percent full.
The tank system must be set up for vapor with drawal.
Keep away from the unit for the first 20 minutes after igniting your unit for the first time, as pumice stones / fire glass could pop
out and cause injury. Should any rocks pop out, discard them.
Always ensure that lava rocks / pumice stones / fire glass are completely dry before use.
Do not paint or color any part of this Fire Table.
Do not sit or rest hands or feet on this Fire Table.