Instructions / Assembly

TROUBLESHOOTING

Burner will not light using igniter

Burner will not light with match

The fire table emits a lot of black

smoke when in use

Hose from gas fire table is pinched

Make sure the hose is not pinched between the fire table and the

source of the gas.

Make sure that the gas ports on the burner are free of any lava

rocks / fire glass so that the flame can flow naturally. Clear out

the mixing chamber located before the Venturi.

Flame is being obstructed at bur-

ner ports or mixing chamber of the

burn tube is blocked or obstructed

Electrode and burners are wet Wipe dry with cloth.

Check that the AA battery is inserted correctly in the igniter or

replace the battery. Make sure the plastic wrap on the battery has

been removed.

Please contact UPHA to request the parts.

Check for residue on the igniter pin or Thermocouple. If dirty,

thoroughly clean the area. Check that the electronic Ignitor Cap

is tightly fitted to the spring. If loose, please adjust the spring

accordingly.

Igniter battery is dead or back-

wards

Igniter Pin cracked or broken-

sparks a crack

Residue on Igniter Pin

No Gas Flow

Check if the LP gas tank is empty. If empty, replace and refill.

If the propane tank is not empty, refer to Problem: Sudden drop

in gas flow on the following page.

Turn the coupling nut about one half to three fourths a turn, until

you feel a solid stop. Do not use tools, tighten by hand only.

Obstruction of gas flow

Check for bent or kinked hose.

Clean the venturi.

Reference Problem: Irreqular flame pattern on the following page.

Clean the burner ports as described there.

Spider webs or insect nest in the

venturi

Burner ports clogged or blocked

Coupling nut and regulator not

fully connected