Instructions / Assembly

9
OPERATION
FOR YOUR SAFETY, READ BEFORE LIGHTING
1. Turn the cylinder valve on the gas tank counter-clockwise to open the gas supply.
2. Close the storing door on the firebowl for the gas tank.
3. Press and hold the Electric Ignitor. Meanwhile, push and turn the Control Knob counter-clockwise to the "LOW" position. Keep pushing the Control
Knob to light the burner.
4. After ignition, release the Electric Ignitor. Continue to push and hold the Control Knob for 45 seconds.
5. If ignition does NOT immediately take place in seconds, push and turn the Control Knob clockwise to "OFF". Wait 5 minutes, then repeat the lighting
procedure as above.
6. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury.
Push the Control Knob and turn clockwise to the "OFF" position.
Turn the cylinder valve on the gas tank clockwise to close the gas
supply if not in use for a long time.(See figure below)
HOW TO EXTINGUISH ?