Instructions / Assembly

8
OPERATION
FOR YOUR SAFETY, READ BEFORE LIGHTING
Before performing a leak test, make sure that no sparks can occur and you are in a spacious outdoor area.
Connect the propane gas tank to the regulator andturn thevalve on the unit to the “off” position.
Brush a soap and water mixture on all connections.
Make sure the igniter battery has been installed properly. The igniter will not operate otherwise.
Before operating, smell around the appliance and next to the ground for gas odors. If you smell gas or a leak is discovered, immediately turn the gas
valve off, disconnect propane gas tank and do not use the appliance until the leak is repaired.
After turning the gas supply, if bubbles occur on any connection there may be a leak.
Do not use the appliance if any part has been submerged under water. Immediately call a qualified service technician to inspect the unit and to
replace the part.
Do not use the heating unit without inspecting the gas hose (if applicable).
If there are signs of wear or abrasion, please immediately replace the hose.
Pumice stones/lava rocks/Lava Glass could pop up and strike somebody’s face during the process of lighting this unit; stand away from the unit for
the first 20 minutes after igniting.
Wait 10 minutes after extinguishing flame prior to replacing a lid ( if applicable ) or protective cover on to the Fire Table.
If there are signs of wear or abrasion on the hose, you must replace the Gas Hose (12). The Gas Hose must be supplied directly by manufacturer.
Inspect the Gas Hose ( 12 ) before using the Fire Table.