Use and Care Manual
Kinetik and Adventure Power are registered trademarks of Universal Power Group, Inc.
Exhaust
Before lling, ensure your new battery is the correct size for your vehicle. Once the battery is lled, it cannot be returned to vender.
Only use the acid pack that comes with your battery.
Fill all cells to the "FULL" mark and wait 30 minutes.
After 30 minutes, any cell that has settled below the "FULL" mark should be topped o to the "FULL" mark.
Replace the sealer caps before charging the battery.
Charge the battery fully before installing.
Never charge this battery with a charger that delivers more than 1.6 amps of current. Larger chargers will harm the battery.
For optimum performance, UPG recommends charging and maintaining with the Adventure Power Maintainer 1000 battery charger.
This charger/ maintainer can remain connected to the battery indenitely.
488 S. Royal Lane Coppell, Texas 75019 P 469.892.1122 T 866.892.1122 F 469.892.1123 sales@apbatteries.com
S1515-1
Warranty
14.8 V @ 25 C
1 Year Full Replacement
L: 6.30” (160 mm) W: 3.54” (90.0 mm) H: 6.38” (162 mm)
www.upgi.com
16 Ah
12 Volts
11.0 lbs. (5.00 kgs)
1.6 A
D
Maximum Charging Voltage
All specications are subject to change without notice.
www.apbatteries.com
Specification
Charging Instructions
Filling Instructions
Physical Dimensions: in (mm)
Due to continuous improvements to our products, product may vary slightly from depiction.
Equivalent to YB16B-A1
UPG No. 42533
HIGH PERFORMANCE CONVENTIONAL
AP SERIES
POWERSPORTS BATTERIES
Copyright 2015 Universal Power Group, Inc. All rights reserved.
C