User guide

UPCOM TECHNOLOGIES
7
Monitors and Controls
Monitor signals and Control lines are present on the M & C Connector when this option is
installed. With a Microcontroller equipped system, all Monitors and Controls can also be
accessed remotely by RS-232 / RS-485 to a Windows based PC; and other Alarms become
available as well. Units equipped with a Redundancy option have a Microcontroller M & C
installed by default.
The full M & C Connector pin-out is listed here for convenience. However, always check the
Test Bench Record supplied with the unit to view which interfaces have been installed on your
unit, or to see if it has had any custom modifications.