User guide

UPCOM TECHNOLOGIES
11
Quick Start Guide
 Connect the low power L Band output from a modulator or a 10MHz Insertion Box to
the BUC Input port.
 Nominal input levels are approximately -50 to 0 dBm depending on the output power
level of the unit.
 DO NOT FEED DC VOLTAGES TO THE L BAND INPUT
 The BUC’s output is taken from the waveguide port (RF Out). Caution should be
observed here to make sure that the antenna or a suitable termination is connected to
this port before operating the BUC.
 Ensure there is proper clearance around the unit.
 Connect the chassis ground to a proper ground connection
 Connect AC Input power to the connector. The unit will be enabled almost immediately,
provided it is not forced into a mute state.
 Optional - Connect the M & C interface to an available COM port on your computer
and/or to your analog based monitoring and control equipment.
 Optional - Run the UPCOM TECHNOLOGIES Monitor and Control Program.
 Recommendation: if possible install the BUC with the fans facing down in order
to avoid accumulation of debris inside the fans that may block the fans.