Instructions / Assembly

6.
7. Align the holes in the back plate (E) with the pre-assembled
threaded nipples, then attach the back plate (E) to the mounting
plate (A) with the previously removed threaded balls (F). Hand
tighten until snug.
Note: The back plate (E) should be snug against the wall and the
threaded balls (F). If not, adjust the length of the pre-assembled
threaded nipples on the mounting plate assembly (A) by unscrewing
the pre-assembled hex nuts and then screwing the threaded nipples
in or out of the mounting plate (A) until the length is achieved.
Tighten the hex nuts and back to step 7.
8. Install bulb (Not included) (Please do not exceed the maximum
wattage recommended on the socket.)
9. Check everything is already installed properly, then you could turn on the light. Enjoy!
CLEANING
To clean, wipe the fixture with a soft cloth. Do not use abrasive materials such as scouring pads or powders, steel
wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference in case you need to order replacement parts. All parts for this fixture can be
ordered from the place of purchase. Be sure to use exact wording from illustration when ordering parts.
Page: - 4 - / 4
[e-mail]