Instructions / Assembly

[phone] Working hours : Mon - Fri 9:00 - 16:00 EST
[e-mail]
5. To use the fixture with motion sensor, please be sure to read this instruction.
illustration only
describes the sensor
specification, please
refer to the actual
product for details.)
• For further information aboutA, B and C in the chart, please refer to the illustration.
• The above specification is measured at 25°C (mounted at the suggested height), and the actual use may
vary in different situations.
Basic Functions Description:
1. Start-up
First-time powered on, the light keeps at 100%
brightness for several seconds and automatically
enters Test Mode.
2. Test Mode
In Test Mode, the initial brightness of light is 40%,
and increases to 100% (but only for several
seconds) each time someone moves near the light.
3. Auto Mode
In Auto Mode, brightness maintains at 40% for all
night (but the light turns off about 1 minute after
being exposed to daylight).
When someone moves near the light, LED indicator
flashes 3 times, and brightness immediately
increases to 100% (but back to 40% without motion
detection about 1 minute after).
4. Manual Mode
In Manual Mode, brightness maintains at 100% for
7-9 hours at night (but about 1 minute after being
exposed to daylight, the light turns off and exit
Manual Mode).
General Instructions:
» How to test if the Motion Detection Function works
properly:
Solution: Test Mode allows you to check the light
and test the Motion Detection Function for about 2
minutes. After that, it enters Auto Mode automatically.
» How to enter Test Mode again:
Solution
: Turn your wall switch off, then turn on after
5 seconds.
»
How to skip Test Mode and enterAuto Mode
directly:
Solution: At Test Mode, turn off your wall switch,
and then turn on. When the LED indicator flashes
quickly 6 times, it shows that light enters Auto
Mode successfully.
»
How to keep the light at 40% brightness for all
night and 100% when someone is around:
Solution
: Use Auto Mode
» How to keep the light at 100% brightness for 7-9
hours at night:
Solution: Use Manual Mode
» How to enter Manual Mode at Auto Mode:
Solution
: When dark or at night, make sure the
light is on at Auto Mode, then turn off and on your
wall switch. When the LED indicator flashes quickly
6 times, it shows that the light enters Manual Mode
successfully.
» How to check if the light is still at or already
returned to Auto Mode after light off at daytime:
Solution: Do not turn off your wall switch and the
light automatically turns on at Auto Mode when
dark or at night.
» How to exit Manual Mode and return to Auto Mode
when light on at Manual Mode:
Solution: Turn your wall switch off and on. When
LED indicator quickly flashes 3 times, it shows that
the light enters Auto Mode and already exited
Manual Mode.
Or wait till daytime, the light automatically turns off
about 1 minute after being exposed to daylight and
exits Manual Mode. At this time, LED indicator
should quickly flash 3 times.
Page: - 4 - / 4
NOTE:
(This
Sensor Specification Details:
A: Suggested Mounting Height:
1.8 m ~ 2.2 m
B:
Motion Detection Length:
35 ft (Max.)
C: Motion Detection Angle:
220° (Max.)
Working Temperature:
-30~50°C