Instructions / Assembly

[phone] Working hours : Mon - Fri 9:00 - 16:00 EST
[e-mail]
Page: - 3 - / 4
Step A1 »
Unscrew knob nuts (F) from back plate (E), then set them aside for later installation.
Step A2 »
Carefully pass the supply wires from the outlet box through mounting plate (D).
Step A3 »
Make wire connections
Connect wires as below wires connection shown. PLEASE NOTE THAT GROUND WIRE IS BARE
COPPER WIRE, NEVER CONNECT OTHER WIRES TO GROUND WIRES.
Connect ground wires according to the below chart
Connect wires according to the below chart
Twist wires together with plastic wire connectors until tightly joined, and wrap each
connector with approved electrical tape. Be sure that no wire strands are exposed
and then carefully tuck all wires into the outlet box.
Step A4 »
Align the holes in back plate (E) with the pre-assembled mounting screws, then attach back plate
NOTE: back plate (E) should be snug against the wall with knob nuts (F).
If not, remove back plate (E), adjust the threaded length of pre-assembled
mounting screws on mounting plate assembly (D):
• first, unscrew the pre-assembled hex nuts;
• then, screw the pre-assembled mounting screws in or out of mounting
plate (D);
• when the secure length is achieved, tighten the pre-assembled hex nuts
and back to Step A4.
Step A5 »
1) Unscrew socket ring (J) from socket (G).
2) Install the bulb (Not included) (Please do not exceed the maximum wattage recommended on
the socket. Please use incandescent bulb, if using LED bulb, use adjustable LED light source.)
4. Check everything is installed properly, then you could turn on the light. Enjoy!
ORDERING PARTS
Keep this sheet for future reference in case you need
to order replacement parts. All parts for this fixture can
be ordered from the place of purchase. Be sure to use
exact wording from illustration when ordering parts.
CLEANING
To clean, wipe the fixture with a soft cloth. Clean glass
with a mild cleaner (such as mild and non-abrasive
soap). Do not use abrasive materials such as scouring
pads or powders, steel wool or abrasive paper.
Then carefully place glass shade (I) on socket (G), and secure it with socket ring (J).
(E) to mounting plate (D) with the previously removed knob nuts (F). Hand tighten until snug.
Secure mounting plate (D) to the outlet box with mounting screws (A).