Operation Manual
UNO
X
R
cycle and the START/STOP LED will remain turned 
on. 
If during the 45 seconds of flashing digits (0.00) the 
operator set a time (using the + or – keys), the oven 
automatically starts functioning (with temperature 
and percentage of humidity entered in the last used 
step).
At the end of the 45 seconds or if the cooking cycle 
is interrupted by pressing the START / STOP keys, 
all the parameters previously set will turn into 0 (the 
operator will be in the same situation there is when 
the oven has just been turned on) and the START/
STOP LED will be switched off.
Automatic pre-heating
An automatic pre-heating phase is run only when 
you use the oven with programs.
When you start the program with the START / STOP 
key, the oven starts to heat up the cavity and you do 
not see any digit on the displays. When the oven 
reaches the pre-heating temperature, it gives a long 
sound. At this point, it is necessary to open the door, 
place the trays with the food to be cooked inside the 
oven and close the door: the chosen program will 
start automatically.
Pre-heating temperature is equal to the set 
temperature plus 30°C.
MANUAL WATER
While the oven is working (both in the manual and 
in the programmed mode) it is possible to introduce 
water inside the cavity by pressing the “MANUAL 
WATER” key. The electric water valve works only for 
the time the key is pressed. 
3.3  DESCRIPTION AND USE OF Manual 
CONTROL BOARD 
COOKING TIME SETTING
Time of cooking can be set by turning clockwise 
the knob situated on left side of the control board: 
time range is 0 -120 minutes.
By turning the knob anti-clockwise the oven works 
continuously.
By turning the knob you start the oven: the fan 
spins and internal light turns on.
When cooking time is over, the knob turns to “0” 
position and the oven turns off.
COOKING TEMPERATURE SETTING
The cooking temperature inside cooking chamber 
is set through the temperature knob ( on right 
side of control board ): temperature range is 0 
– 300°C.
Temperature warning light on indicates that heating 
element is on; when set temperature is reached, the 
light turns off.
ENGLISH
ENGLISH
10










