Datasheet

13
1. After connection the appliance witht the power
socket, the display shows 12:00 .
2. Press once the button PROG. The display gets
lighted.
3. In the upper right corner of the display CLOCK
is shown.
CLOCK
12:00
4. Press the buttons STD and MIN until the cor-
rect time is shown.
5. After approx. 10 seconds without operating any
key, the display returns into the basic dialogue,
the lighting is switched off.
PRESETTING OF THE CLOCK
The coffeemaker from allows to prepare coffee either manually or with the timer function which can be
preset 24 hours in advance.
1. Take out the water tank (open the lid and use
the integrated handle to pull it out) and ll it
with the desired volume of cold water. The mar-
king refers to the number of cups. Place the
water tank on the machine.
Attention:
For safety reasons, the water tank has an over-
ow opening at the back. Please observe the
MAX mark and do not overll the tank, as water
may ow out.
2. Please keep in mind that a certain portion of
the water may evaporate during brewing.
3. For lling in ground coffee, open the swing-
out lter. Insert the lter holder. Take care that
the projection of the lter holder ts into the
recesses of the swing out lter. If not placed
correctly, the lter cannot be closed.
4. Insert the permanent lter into the lter hol-
der.
5. Optionally you can also use lter paper (size
1x4, 0994) after having folded the edges. The
lter paper must not project over the lter hol-
der.
6. Add the desired amount of ground coffee, de-
pending on your taste 5-7 g (max. 1 measuring
spoon) of medium ground coffee. If the cof-
fee is ground too ne, the lter paper may be
clogged up and the coffee may overow.
7. Close the swing lter, until it clicks into place.
8. Place the carafe with lid on the warming plate.
9. Press the button EIN/AUS (On/OFF). The red
control light EIN (ON) will turn on and brewing
starts.
10. After the end of brewing you can switch off the
appliance pressing twice the button EIN/AUS
(On/OFF).
11. If the appliance is not switched off, the war-
ming plate keeps warm. Two hours after begin-
ning of the brewing, the appliance will switch
off automatically.
12. If the appliance is switched off earlier the
appliance can be scaled. In this case please
follow the instructions of the chapter Cleaning
and Descaling.
PREPARATION OF COFFEE WITHOUT TIMER FUNCTION
PREPARATION OF COFFEE WITH TIMER FUNCTION
1. Please follow steps 1-8 of the previous chapter
Preparation of coffee without timer function.
2. Then press the PROG button once and check,
if the clock has been set correctly (see chapter
Presetting of the clock).
3. Then press again the button PROG to preset the
brewing. The display shows TIMER in the upper
left corner.
CLOCK
12:00
Press the buttons STD and MIN until the re-
quired time is preset.