User manual

- 19 -
Installation
Flushing
Flushing should take place when the water purifier:
● is new and has never been used before
● is reinstalled after having been stored/protected
against freezing
● has been cleaned, in order to rinse out the
detergent
● has been fitted with a new membrane.
Do not use the pure water until flushing
is complete.
First check that:
● the shut-off valve on the feed water is open
● the connection for the feed water is watertight
● the reject water outlet and pure water connections
are watertight
● the filter container is properly tightened.
Check that there is no leakage from the connections
during flushing. In the event of leakage, pull out the plug
and fix the leak. Connect the plug and perform flushing
again as described below.
1. Check that the water purifier is in standby
mode.
2. Press the service button, using a pen, until
both
the service and filter lights come on
(approx. 15 seconds). The lights on the
faucet now flashes rapidly.
3. Release the button. The flushing procedure
is now performed and takes 25 minutes.
Water will be purified at the end of the
procedure.
This water must not be used.
When the flushing procedure is complete,
the lights on the faucet goes out.
The water purifier is now ready to be used.
Moving the water purifier
If you move the purifier from one place to another, you
should remember the following points:
● Close the shut-off valve for the feed water before
removing the feed water hose.
● Pull out the plug.
● Always transport the appliance upright.
● Install in accordance with the installation instructions.
If the water purifier will not be used for four months or
more, or if it is to be disconnected from the water and
electricity for several days, it should be put into storage.
See «Storage».