User manual

Connecting the water purifier

Before the water purifier is placed in its intended position,

remove the plug at the end of the reject water hose and

the two plugs in the connections on the purifier, see fig. F.

Connect the two hoses and the faucet cord to the appliance

as shown in fig. G.

Feed water

1. Screw the bent end of the feed water hose

onto the water purifier. Check that the seal is

in place in the connection. See fig. G no. 1.

2. Open the shut-off valve on the feed water

and check that there is no leakage at the

feed water hose.

Pure water

The pure water is routed via the pure water hose to the

faucet installed on the sink unit.

1. Connect the pure water hose from the pure

water faucet to the water purifier. Push the

hose into the bottom position, up to the mark

(approx. 19 mm). See fig. G no. 2.

Reject water

The reject water hose has already been connected to

the water purifier on delivery. The other end of the hose

is connected to the waste water pipe.

Indicator light

1. Connect the cable from the faucet indicator

light, as shown in fig. G no. 3, and place the

water purifier in the intended position.

Electrical connection

1. Connect the plug to the earthed wall socket

as shown in fig. J.

The water purifier starts and flushes for 90 seconds.

Flushing is performed every time the plug is connected.

Do not drink the water until the flushing

procedure under «Flushing» has been

completed.

Installation

- 18 -