User manual

Unpacking
● If the appliance has been damaged during
transportation, you should immediately notify
the company responsible for delivering it.
● Carefully lift out the water purifier by taking
hold of the plastic bag and the rear handgrip.
The appliance can be damaged if it is lifted
in any other way.
● Check the purifier for any signs of damage
and check that no accessories are missing.
Any damage, faults or missing parts should
be notified to the supplier.
● Do not leave the packaging material lying
around so that children can play with it.
Positioning the water purifier
The water purifier must be installed under the sink unit
and the following points should be observed:
● The purifier is installed upright, without support,
on a horizontal surface that can take the load.
● The installation space should be close to
cold water supply, drainage and an earthed
electrical supply.
● It should be easy to inspect the control panel.
● It should be possible to open the front cover
so that the filter container can be accessed.
● The water purifier should be installed with a
2 cm gap to any adjacent fittings or walls to
ensure good ventilation around the appliance.
● Connections can be routed in any direction
from the connection point; make sure no
connections are crushed or damaged.
The dimensions of the area required for the
water purifier are specified in fig. A.
Installing the pure water faucet
The pure water faucet is supplied complete with a pure
water hose. The faucet can be raised and lowered and
can be turned in either direction.
If the hose has to be cut, use a sharp knife e.g. a carpet
knife, so that a flat, smooth and circular cut surface is
achieved, see fig. B. This is essential in order for the
connection to be watertight.
If the distance between the faucet's highest
point and the water purifier's highest point is
less than 500 mm, water can drip from the
faucet during flushing. See fig. A.
1. Mark out the position on the sink unit where
the pure water faucet is to sit. Make sure
there is room on the underside for the hose
and the faucet fittings.
2. Drill a hole with a diameter Ø 20 mm.
3. Install the pure water faucet on the sink unit
as shown in fig. C1. Maximum unit thickness
is 40 mm. Adjust the height of the faucet to
the desired position and secure it with the
black nut. Make sure that the cable to the
faucet does not get jammed during
installation. See fig. C2.
- 16 -
A
C1
B
C2
Installation