User manual

- 13 -
ON light not lit.
Yellow light on the faucet flashing
and filter light flashing.
Yellow light on the faucet flashing
and filter light lit.
Yellow light on the faucet flashing
and service light flashing.
Yellow light on the faucet flashing
and service light lit.
Yellow and Green light on the
faucet lit and service light lit.
Noise from the water purifier.
Motor not starting.
Yellow or green light on the faucet lit.
Motor not starting.
Low flow from the faucet.
No flow from the faucet.
Dripping from the faucet during
flushing.
Unpleasant smell.
If the water purifier is not working
Trouble-shooting table
To protect the user and the water purifier from incorrect
use, there are built-in alarms which cause the purifier to
give an indication and stop. The table below gives probable
causes of warnings given by the water purifier.
● The water purifier is not receiving power.
- Is the plug connected?
● Indicates that it is time for filter replacement.
- Change filter in accordance with «Replacing the filter».
● Emergency stop due to filter not having been replaced.
- Change filter in accordance with «Replacing the filter».
● Indication of deterioration in water quality.
- Contact your dealer for membrane replacement.
● Emergency stop due to air in the system caused by filter replacement.
- Pull out the plug and connect it again. Let the purifier go throug the
flush before starting production of pure water.
● Emergency stop due to deterioration in water quality.
- Contact your dealer for membrane replacement.
● The water quality measurement is not working.
- Contact your dealer for replacement.
● The water purifier is not receiving sufficient water.
- Is the inlet pressure lower than 1.5 bar during operation?
- Is the grid blocked? - Clean the grid.
- Is the filter blocked? - Change filter.
● The overflow protection has been triggered.
- Pull out the plug and wipe clean the base plate.
- If it is triggered again, call your dealer.
● The water purifier is flushing.
- Wait for 5 minutes.
- Is the faucet cord connected?
- Is the membrane blocked?
- Descale the water purifier in accordance with «Descaling».
- Make sure the pure water hose is not jammed.
- Is the shut-off valve for the feed water open?
● The hight distance between the faucet and the water purifier is less
than 500 mm.
- See «Installation».
● Odour problems can be caused by micro-organisms in the water because the
water purifier has not been used for an extended period (1 week or longer).
- Clean the water purifier in accordance with «Disinfection».
CHECK/REMEDIAL ACTIONSYMPTOM
If you are still having problems with your water purifier after having read through and tried the procedures described
in the trouble-shooting table, contact your dealer.
extinguished flashing lit