User manual

Cleaning the grid
The grid blocks larger particles and is situated in the
feed water connection. If the flow is reduced or the
purifier makes a noise, the grid may be blocked.
1. Check that the water purifier is in standby
mode.
2. Close the shut-off valve at the feed water
connection.
3. Unscrew the feed water hose from the water
purifier.
4. Using pliers or similar, grip and pull out the
grid in accordance with fig. G. Remember
which way the grid is installed.
5. Clean and rinse the grid. Reinsert the grid
in the feed water connection using the
pliers.
6. Screw back the feed water hose.
7. Open the shut-off valve at the feed water
and check that there is no leakage.
The grid is now clean and the water purifier is ready
to be used.
- 12 -
G
Maintenance
Regular care of the water purifier
Listed below are things you need to remember in the regular care of your water purifier. The points are listed
according to how often they need to be performed:
● Every day, check that the indicator lights are not
indicating that something has to be attended.
● Keep the appliance clean. Externally, the appliance
may only be cleaned with a damp cloth. Do not use
a wet cloth and do not pour water over the
appliance. Do not use detergents.
● Once a month, check that all the connections are in
place and watertight. Wipe off any condensation
that has collected on the base plate.
● Make sure that you always replace filter in time.
The lifetime of filter depends e.g. on the feed water.
● After replacing a filter, stand the filter so that most of
the water runs out over a few minutes. The filter can
be discarded with normal household rubbish, as it
does not contain any environmentally hazardous
substances.
● Depending primarily on the hardness of the feed
water and its content of micro-organisms, the water
purifier should be descaled when the flow is reduced
and disinfected if the water smells or tastes bad.
● When the capacity of the purifier is reduced even
after filter replacement and descaling, contact your
dealer for membrane replacement.
● If the feed water has been classed as unfit, the water
produced by the water purifier should be tested
once a year by an approved lab.
● If the water purifier is not going to be used in the
next 4 months or is going to be disconnected from
water and electricity, the water purifier should be put
into storage.