User manual

Disinfection

If the feed water has a high content of micro-organisms,

the water might develop an odour if the water purifier is

not used for an extended period of time (1 week). It is

then necessary to disinfect it. After the disinfection the

filter has to be changed.

The disinfectant, sodium hypochlorite (concentration

approx. 3.5%, odourless), can be purchased from

supermarkets or chemists.

The disinfectant must be kept out of reach

of children! Wash your hands after using it.

1. Check that the water purifier is in standby

mode.

2. Press the service button, using a pen, until

the service light comes on. Release the button.

The light on the faucet now flashes rapidly

for 15 seconds. This prevents flushing from

taking place during disinfection.

3. Disconnect the filter container in accordance

with «Replacing the filter», points 2 - 5.

Remove the filter and discard it (should not

be saved).

4. Fill the container with 7 dl of lukewarm water

and pour in 1/4 dl of disinfectant. See fig. C.

5. Screw the filled container in place.

6. Start the water purifier and produce pure

water for 30 seconds.

7. While production is in progress, pull out

the plug as shown in fig. D. Allow the water

purifier to stand for around 30 minutes.

8. Disconnect the container and insert a new

filter into it, in accordance with «Replacing

the filter», points 7 - 8.

9. Connect the plug.

10. Close the front cover.

11. Flush the water purifier in accordance with

«Flushing».

Do not use the purified water until flushing

is complete.

The disinfection process is now finished. The water

purifier is ready to be used.

- 10 -

Maintenance