User Manual

Table Of Contents

C INTERFACE INFORMATION

EXPOSURE TO CLEAN

When a failed print occurs and there are some residues left in the bottom of Resin Tank, you need

to exposure to clean it. After that, please wear nitrile gloves and take the solidified piece out.

RESET Z-AXIS ZERO POSITION AND LEVELING BUILD PLATFORM

If you change for a new Build Platform or the printing model may not stick onto the Platform,

please reset z-axis zero position and leveling the Build platform. You will use an A4 paper and the

Hexagon Wrench in the accessory box sent with your printer.

After leveling, please put the A4 paper under Build Platform and reset again. It finishes if you may

feel the frictional force between Platform and A4 paper.