Manual

July 2017 | uniz3d.com
36
9. It is suggested to use the resin tank cover to store resin in the tank.
10. If the machine is not used for a long time after using the resin level
control system, please clean the resin injection conduit by ethyl alcohol
from the CLEAN bottle;
1. Plug the cap in air-bleed hole on the top of resin bottle;
2. Pull up the resin bottle and put it flat on table;
3. Take down the cap of CLEAN bottle;
4. Insert the CLEAN bottle downward in the resin bottle holder;
5. Use the awl to pierce an air-bleed hole on the top of resin bottle;
6. Change a new resin tank and click on “FILL” button in the software control
interface, cleaning the resin level control system conduit by ethyl alcohol
from the CLEAN bottle, click on “FILL” again to stop washing;
7. Plug the cap in air-bleed hole after cleaning ;
8. Pull up the CLEAN bottle and put it flat on table;
9. Click on “FILL” to clean out the residual ethyl alcohol in the conduit, click on
“FILL” again to stop working.