Manual

MAN70628 REV A
July 2017 | uniz3d.com
29
D TROUBLESHOOTING
Problems
Reason
Solutions
1. The first layer does not stick
The calibration for platform
initial point is not in place
Calibrate again
Build platform surface is not
rough
Use provided sandpaper to roughen the surface
of the build platform and clean up
2. Printed model fault / layered
The suction force between the
resin tank film and models is
too strong
Replace a new resin tank if you have，
Remove the resin tank, clean the LCD panel and
the resin tank film toward the panel, firstly
wipe them with alcohol, and then wipe them
with a dry paper towel. (Please note only touch
the glass part of the screen, to avoid touching
the black tape area)
Increase cooling time properly
Insufficient adhesion between
printed layers
Increase exposure time properly