Manual

MAN70628 REV A
July 2017 | uniz3d.com
23
 Thickness is the layer thickness, which is related to Z resolution.
 Exposure Time is the exposure time of a layer in this segment, it may
vary due to different layer thickness setting or different resin types, i.e.
zWax resin takes about 2x exposure time per layer compare to zABS.
 Cool Down Time is the time to cool down the exposed layer to protect
the polymer film from overheating. For sustained low peel force and
prolonged film life, it is recommended to keep the film temperature
below 50deg C. Overheating will cause the film to warp, delaminate, or
even break.
Tips: Avoid exposing the same spot or area over and over, try to orient the
model’s walls or pillars in oblique angle so the exposure area changes every next
layer.
Pressing the “Advanced” Button will open following sub menu
 Motor Speed defines the speed of electric motor that controls the peel
motion of the platform.
 Rise Height defines the travel height of the peel motion.