Manual

MAN70628 REV A
July 2017 | uniz3d.com
13
After processing
1. Remove the Build Platform
After printing, take on rubber protective gloves, rotate the locking arm
counterclockwise to unlock the build platform, pull out and remove it.
Tips: After removing the build platform, remember to close the top cover to
prevent the remaining resin being cured by external light.
2. Wash Your Print
Use tissue to wipe off the remaining resin, rinse the model on the build
platform by alcohol, the gap and hole should be cleaned particularly. If
possible, use supersonic washing machine to clean.
3. Finish Your Print
1) Remove the models.
Use a shovel to remove the models
2) Cut off supports.
Use clip or scissors to cut off the supports.
3) Post-processing
Use sandpaper to polish the supports’ contacting points; smooth the tough
surface; leave the model under UV light or sunlight to make it fully cured.