User's Manual

21
To change the modem setting, do the following:
1. Go to [Start > Settings > Control Panel] and double-click on Modem Settings icon.
You will see a similar dialog box.
2. Click on the pull-down menu and select the country where it is applicable. Click on
OK to exit.
Ethernet
Your computer is equipped with a 10/100/1000Base-TX Fast Ethernet network adapter. Connect
the active LAN cable to the RJ-45 LAN port located on the left side of the computer. This allows
you to access and transmit data in the local area network.
Connecting to the Network
Use Unshielded Twisted Pair (UTP) Ethernet cable only.
1. Insert one end of the UTP cable into the network connector until the connector snaps
securely into the receptacle.
2. Either connect the other end of the cable to an RJ-45 jack wall outlet or to an RJ-45
port on a UTP concentrator or hub in the network.
Cabling Restriction for Networks
The following restrictions should be observed for 100/1000BASE-TX networks:
 The maximum cable run length is 100 meters(m) (328 feet[ft]).
 For 100/1000-Mbps operations, use Category 5 wiring and connections.
Consult Windows manual and / or Novell Netware user’s guide for the software
installation, configuration, operation of the network.