User's Manual

■ appendix D Using Power Cinema
2. Installation.
2-1 Before install Linux system, Please make sure you have a
"4th partition" and it should be 500MB if not, please create
a new one.
2-2 Insert the PCM4 Linux installation disc into the optical drive,
and reboot the system.
2-3 When system boot procedure finished, you should see a
warning message. Read it carefully.
2-4 In 2-3 step, if you recognize the condition, please type
"YES", and then press the "Enter" key.
Note: It is on you own risk to do the installation. Please make sure everything
goes fine.
2-5 Installing system, it will take about 2~3 minutes.
2-6 When install is finish, please type "poweroff", and press the
"Enter" key to shutdown system to finish last step.
Note: If any exception (for example, you didn't type "YES" in the 4th step),
you will be thrown into a Linux shell. If you still want to install PCM Linux, you
can continue the job by typing "install.sh", and you will be in step 2-3 as above.
C-3