Quick Start Guide
Table Of Contents
- 01-Front Cover
- 02-Title Page
- 03-Body
- 1 Appearance Description
- 2 Mount Your Camera
- Hardware Installation
- Waterproof Measures
- Waterproof Components for RJ45 Plug
- 1. Attach the seal ring to the network interface.
- 2. Mount the waterproof components. You can crimp the inner wires of the cable with the RJ45 plug first and then cover the waterproof components. You may also cover the waterproof components first.
- 3. Insert the cylindrical waterproof ring into bolt.
- 4. Insert the cable into the network interface and screw the waterproof bolt in.
- 5. Screw in the waterproof bolt lid.
- 6. Finish the waterproof installation.
- Waterproof Tail Cable
- Waterproof Components for RJ45 Plug
- 3 Set Your Camera over the LAN
- 4 Access Your Camera
- 04-Back Cover
13
System Requirements for Your PC
Item
Requirements
Operating
system
Microsoft Windows 8/Windows 7/Windows XP
(32-bit or 64-bit). Microsoft Windows 7 (32-bit) is
recommended.
CPU
2.0 GHz or higher, dual-core. Intel i3 CPU or higher is
recommended.
Memory
At least 1 GB. 2 GB (or higher) is recommended.
Graphic
card
At least 128 MB display memory. Mainstream
discrete graphics with more than 1GB display
memory are recommended. The hardware should
support DirectX9.0c.
Note:
Make sure that the latest driver is installed on
graphic card.
Sound
card
Required.
Note:
Two-way audio and voice broadcast require the
latest driver on sound card.
Network
card
Gigabit Ethernet network cards (or higher) are
recommended.