Quick Start Guide
Table Of Contents
- 01-Front Cover
- 02-Title Page
- 03-Body
- 1 Appearance Description
- 2 Mount Your Camera
- Hardware Installation
- Waterproof Measures
- Waterproof Components for RJ45 Plug
- 1. Attach the seal ring to the network interface.
- 2. Mount the waterproof components. You can crimp the inner wires of the cable with the RJ45 plug first and then cover the waterproof components. You may also cover the waterproof components first.
- 3. Insert the cylindrical waterproof ring into bolt.
- 4. Insert the cable into the network interface and screw the waterproof bolt in.
- 5. Screw in the waterproof bolt lid.
- 6. Finish the waterproof installation.
- Waterproof Tail Cable
- Waterproof Components for RJ45 Plug
- 3 Set Your Camera over the LAN
- 4 Access Your Camera
- 04-Back Cover
Use the power cable connector delivered with the camera.
Make sure the connector is in good condition (clip) and
secured into place. Do not fully stretch the power cord,
otherwise, the connector may be loose or disconnected due
to vibration or shake.
Use waterproof tape to protect the end of the tail cable.
Keep the tail cable from water.
When cleaning the camera, wipe the surface using clean and
soft cloth dipped with alcohol. When cleaning the lens, use
small amount of neutral detergent. Do not use thinner or
benzene.
Maintenance
If there is dust on the front glass surface, remove the dust
gently using an oil-free brush or a rubber dust blowing ball.
If there is grease or a dust stain on the front glass surface,
clean the glass surface gently from the center outward using
anti-static gloves or an oil-free cloth. If the grease or the
stain still cannot be removed, use anti-static gloves or an
oil-free cloth dipped with detergent and clean the glass
surface gently until it is removed.
Do not use organic solvents, such as benzene or ethanol
when cleaning the front glass surface.