Quick Start Guide
Table Of Contents
- 01-Front Cover
- 02-Title Page
- 03-Body
- 1 Appearance Description
- 2 Mount Your Camera
- Hardware Installation
- Waterproof Measures
- Waterproof Components for RJ45 Plug
- 1. Attach the seal ring to the network interface.
- 2. Mount the waterproof components. You can crimp the inner wires of the cable with the RJ45 plug first and then cover the waterproof components. You may also cover the waterproof components first.
- 3. Insert the cylindrical waterproof ring into bolt.
- 4. Insert the cable into the network interface and screw the waterproof bolt in.
- 5. Screw in the waterproof bolt lid.
- 6. Finish the waterproof installation.
- Waterproof Tail Cable
- Waterproof Components for RJ45 Plug
- 3 Set Your Camera over the LAN
- 4 Access Your Camera
- 04-Back Cover
gently. If the camera will not be used for an extended period
of time, put on the lens cap to protect the sensor from dirt.
Do not aim the camera lens at the strong light such as sun or
incandescent lamp. The strong light can cause fatal damage
to the camera.
The sensor may be burned out by a laser beam, so when any
laser equipment is being used, make sure that the surface of
the sensor not be exposed to the laser beam.
Make sure the camera operates in an environment where
the temperature and humidity meet requirements. Keep the
camera from excessive pressure, vibration, moisture, dust,
and intensive electromagnetic radiation.
Keep the length of the power cord between the power
adapter and the camera within 1.5 meters, otherwise, the
power voltage on the camera may be lowered and may
cause exception.
Disconnect power before you move the camera. The camera
is powered on when the power cord is connected to the
power source. Do not move the camera by lifting the tail
cable.
Do not cut the tail cable. Exposed tail cables may cause short
circuit and damage the camera.