Quick Start Guide
Table Of Contents
- 01-Front Cover
- 02-Title Page
- 03-Body
- 1 Appearance Description
- 2 Mount Your Camera
- Hardware Installation
- Waterproof Measures
- Waterproof Components for RJ45 Plug
- 1. Attach the seal ring to the network interface.
- 2. Mount the waterproof components. You can crimp the inner wires of the cable with the RJ45 plug first and then cover the waterproof components. You may also cover the waterproof components first.
- 3. Insert the cylindrical waterproof ring into bolt.
- 4. Insert the cable into the network interface and screw the waterproof bolt in.
- 5. Screw in the waterproof bolt lid.
- 6. Finish the waterproof installation.
- Waterproof Tail Cable
- Waterproof Components for RJ45 Plug
- 3 Set Your Camera over the LAN
- 4 Access Your Camera
- 04-Back Cover
14
Access Your Camera
Before you begin, check that:
Your camera is operating properly and connected to the
network.
The PC client you are using is installed with Internet Explorer
7.0 or later. IE 8.0 is recommended.
Follow these steps to access your camera through the web
interface:
1. Open your browser, input the IP address of your camera
(default IP is 192.168.0.13) in the address bar and then press
Enter to open the login page.
2. Enter the username (default is “admin”) and password
(default is “123456”) and then click Login.
Install the ActiveX at your first login. For the detailed steps,
see Install the ActiveX. When the installation of the ActiveX
is completed, open your IE to log in.