Quick Start Guide
Table Of Contents
- 01-Front Cover
- 02-Title Page
- 03-Body
- 1 Appearance Description
- 2 Mount Your Camera
- Hardware Installation
- Waterproof Measures
- Waterproof Components for RJ45 Plug
- 1. Attach the seal ring to the network interface.
- 2. Mount the waterproof components. You can crimp the inner wires of the cable with the RJ45 plug first and then cover the waterproof components. You may also cover the waterproof components first.
- 3. Insert the cylindrical waterproof ring into bolt.
- 4. Insert the cable into the network interface and screw the waterproof bolt in.
- 5. Screw in the waterproof bolt lid.
- 6. Finish the waterproof installation.
- Waterproof Tail Cable
- Waterproof Components for RJ45 Plug
- 3 Set Your Camera over the LAN
- 4 Access Your Camera
- 04-Back Cover
11
Avoid short circuit when insulating the cables.
Use self adhesive waterproof tapes that will stick
together with the twisted cables.
Tighten waterproof tapes when wrapping the cables
and make sure the cable connections are fully covered.
You are recommended to put the waterproof cables in
a waterproof junction box which needs to be purchased
separately.
3 Set Your Camera over the LAN
To view and configure your camera via the LAN (Local Area
Network), you need to install the EZStation to find your camera
and change its IP address.
Please contact your dealer to obtain the EZStation.
Please refer to the user manual of EZStation for
detailed information.
1. Connect your camera and your PC as shown in the figure
below to ensure the routing is available.