Quick Start Guide
Table Of Contents
- 01-Front Cover
- 02-Title Page
- 03-Body
- 1 Appearance Description
- 2 Mount Your Camera
- Hardware Installation
- Waterproof Measures
- Waterproof Components for RJ45 Plug
- 1. Attach the seal ring to the network interface.
- 2. Mount the waterproof components. You can crimp the inner wires of the cable with the RJ45 plug first and then cover the waterproof components. You may also cover the waterproof components first.
- 3. Insert the cylindrical waterproof ring into bolt.
- 4. Insert the cable into the network interface and screw the waterproof bolt in.
- 5. Screw in the waterproof bolt lid.
- 6. Finish the waterproof installation.
- Waterproof Tail Cable
- Waterproof Components for RJ45 Plug
- 3 Set Your Camera over the LAN
- 4 Access Your Camera
- 04-Back Cover
5
The above steps are for concealed installation. For an open
installation, lead the cables out from the open slots on the
bottom ring and see Mount the bottom ring. to finish the
installation.
When you adopt open installation, make sure that the
cables can be led out through the open slot on the bottom
ring and then screw the dome to the wall as shown in the
step 4.
Start the Camera
To power on the camera, you need to buy a power adapter
separately. After you have mounted the camera properly, connect
the camera to power.
Lock
Open slot on bottom ring