Quick Start Guide
Table Of Contents
- 01-Front Cover
- 02-Title Page
- 03-Body
- 1 Appearance Description
- 2 Mount Your Camera
- Hardware Installation
- Waterproof Measures
- Waterproof Components for RJ45 Plug
- 1. Attach the seal ring to the network interface.
- 2. Mount the waterproof components. You can crimp the inner wires of the cable with the RJ45 plug first and then cover the waterproof components. You may also cover the waterproof components first.
- 3. Insert the cylindrical waterproof ring into bolt.
- 4. Insert the cable into the network interface and screw the waterproof bolt in.
- 5. Screw in the waterproof bolt lid.
- 6. Finish the waterproof installation.
- Waterproof Tail Cable
- Waterproof Components for RJ45 Plug
- 3 Set Your Camera over the LAN
- 4 Access Your Camera
- 04-Back Cover
4
4. Connect the cable and then secure the dome.
5. Adjust the monitoring direction.
6. Mount the bottom ring.
Connect cable and protect it with
waterproof tape
Attach dome to ceiling
with taping screws
The dome can rotate 360
degrees horizontally
The lens can rotate 80
degrees vertically
Push bottom ring back up and turn
it clockwise to lock into position