User Manual
Table Of Contents
- 01-Front Cover
- 02-Title Page
- 03-Body
- 1 Appearance
- 2 Mount Your Camera
- Hardware Installation
- Ceiling Mount
- 1. Locate the positions of the holes.
- 2. Drill holes on the wall.
- 3. Mount the plastic rivets of self-tapping screws.
- 4. Mount the camera.
- 5. Adjust the monitoring direction of the lens (tighten screws after vertically adjusting the lens).
- 6. Attach the lining and lock it into the buckle on the base.
- 7. Mount the transparent dome housing.
- a. Align the screw holes in the base, and tighten the two cross-recessed pan-head screws on the edge of the transparent dome housing to fix it, as shown by ( in the following figure.
- b. Align the grooves (non-tail cable grooves) of the transparent dome housing to the buckle of the base, and push up the dome housing to fix it, as shown by ( in the following figure.
- Wall Mount
- 1. Locate the positions of the holes.
- 2. Drill holes on the wall.
- 3. Mount plastic rivets of self-tapping screws.
- 4. Mount the camera.
- 5. Adjust the monitoring direction of the lens (tighten screws after vertically adjusting the lens).
- 6. Mount the lining and ensure that it is tightened up.
- 7. Mount the transparent dome housing.
- a. Align the screw holes in the base, and tighten the two cross-recessed pan-head screws on the edge of the transparent dome housing to fix it, as shown by ( in the following figure.
- b. Align the grooves (non-tail cable grooves) of the transparent dome housing to the buckle of the base, and push up the dome housing to fix it, as shown by ( in the following figure.
- Start the Camera
- Ceiling Mount
- Waterproof Measures
- Waterproof Components for an RJ45 Plug
- 1. Attach the seal ring to the copper interface.
- 2. Mount the waterproof components. You can crimp the inner wires of the cable with the RJ45 plug first and then cover the waterproof components. You may also cover the waterproof components first.
- 3. Insert the cylindrical waterproof ring into bolt.
- 4. Insert the cable into the Ethernet copper interface and screw the waterproof bolt in.
- 5. Screw in the waterproof bolt lid.
- 6. Finish the waterproof installation.
- Waterproof Tail Cable
- Waterproof Components for an RJ45 Plug
- Hardware Installation
- 3 Set Your Camera over the LAN
- 4 Access Your Camera
- 04-Back Cover
Make sure the power supply voltage is correct before using
the camera. Use a proper power adapter or a PoE power
supply device. An improper power adapter may damage your
camera.
Disconnect the power before moving the camera, and take
cautions to avoid electric shock when moving it. Once the
cable is connected to the mains, the camera will be
powered.
During mounting, do not remove the protective film in the
outer layer of housing to keep it clean. After finishing the
mounting, remove the film when camera is powered off.
Verify that the length of the power cable between the power
adapter and the camera does not exceed 1.5 m. If the power
cable is longer than 1.5 m, the voltage of the camera is
lowered, causing the camera to work improperly. If it is
required to lengthen the power cable, lengthen the cable
between the power adapter and the mains.
Do not hold the tail cable by hand for weight bearing.
Otherwise, the cable connector of the camera could be
loosened.
Do not cut off the tail cable for connection purposes. A bare
tail cable may easily cause a short circuit, resulting in
abnormality of or damage to the camera.