User Manual
Table Of Contents
- 01-Front Cover
- 02-Title Page
- 03-Body
- 1 Appearance
- 2 Mount Your Camera
- Hardware Installation
- Ceiling Mount
- 1. Locate the positions of the holes.
- 2. Drill holes on the wall.
- 3. Mount the plastic rivets of self-tapping screws.
- 4. Mount the camera.
- 5. Adjust the monitoring direction of the lens (tighten screws after vertically adjusting the lens).
- 6. Attach the lining and lock it into the buckle on the base.
- 7. Mount the transparent dome housing.
- a. Align the screw holes in the base, and tighten the two cross-recessed pan-head screws on the edge of the transparent dome housing to fix it, as shown by ( in the following figure.
- b. Align the grooves (non-tail cable grooves) of the transparent dome housing to the buckle of the base, and push up the dome housing to fix it, as shown by ( in the following figure.
- Wall Mount
- 1. Locate the positions of the holes.
- 2. Drill holes on the wall.
- 3. Mount plastic rivets of self-tapping screws.
- 4. Mount the camera.
- 5. Adjust the monitoring direction of the lens (tighten screws after vertically adjusting the lens).
- 6. Mount the lining and ensure that it is tightened up.
- 7. Mount the transparent dome housing.
- a. Align the screw holes in the base, and tighten the two cross-recessed pan-head screws on the edge of the transparent dome housing to fix it, as shown by ( in the following figure.
- b. Align the grooves (non-tail cable grooves) of the transparent dome housing to the buckle of the base, and push up the dome housing to fix it, as shown by ( in the following figure.
- Start the Camera
- Ceiling Mount
- Waterproof Measures
- Waterproof Components for an RJ45 Plug
- 1. Attach the seal ring to the copper interface.
- 2. Mount the waterproof components. You can crimp the inner wires of the cable with the RJ45 plug first and then cover the waterproof components. You may also cover the waterproof components first.
- 3. Insert the cylindrical waterproof ring into bolt.
- 4. Insert the cable into the Ethernet copper interface and screw the waterproof bolt in.
- 5. Screw in the waterproof bolt lid.
- 6. Finish the waterproof installation.
- Waterproof Tail Cable
- Waterproof Components for an RJ45 Plug
- Hardware Installation
- 3 Set Your Camera over the LAN
- 4 Access Your Camera
- 04-Back Cover
Symbol
Description
malfunction to product.
NOTE! Indicates useful or supplemental information
about the use of product.
Safety Information
Installation and removal of the unit and its accessories must be
carried out by qualified personnel. Please read all of the safety
instructions below before installation and operation.
Installation
This device is a class A product and may cause radio
interference. Take measures if necessary.
If the product does not work properly, please contact your
dealer. Never attempt to disassemble the camera yourself.
(We shall not assume any responsibility for problems caused
by unauthorized repair or maintenance).
Avoid squashing, shaking, or damping the camera during
transport, storage, and mounting. Keep the camera from
vibration sources during mounting.
Please make sure that the ceiling can support more than
50(N) Newton gravities if the camera is fixed to the ceiling.